Applied Environmental Research
Publication Date
2026
Abstract
This research investigated the development of MnFe2O4-based composite adsorbents (MFO@CFA and MFO@CFB) by activating coffee husk-derived biochar with HNO3 and NaOH, followed by synthesis through coprecipitation and hydrothermal techniques. The structural and chemical properties of the nanocomposites were characterized by scanning electron microscopy (SEM) and Fourier transform infrared (FTIR) spectroscopy. Batch adsorption experiments were used to assess ammonium removal efficiency across a range of conditions: solution pH (3–8), contact time (5–120 min), adsorbent dosage (0.2–3 g L-1), and initial ammonium concentration (10–60 mg L-1). The findings indicated that compared with MFO@CFB, which was synthesized from NaOH-activated biochar, MFO@ CFA, derived from HNO₃-activated biochar, presented enhanced surface func-tionality and a superior adsorption capacity. Langmuir isotherm analysis revealed maximum adsorption capacities of 55.25 mg g-1 for MFO@CFA and 28.73 mg g-1 for MFO@CFB, highlighting the potential of MFO@CFA as an effective adsor-bent for ammonium remediation in wastewater treatment. Reusability tests over five adsorption–desorption cycles revealed that MFO@CFB and MFO@CFA retained more than 50% of their initial NH4+ adsorption capacity after regene-ration, which was supported by alkaline desorption and stable MnFe2O4-enabled magnetic separation.
DOI
10.35762/AER.2026021
First Page
1
Last Page
16
Recommended Citation
Do, Thuy-Tien; Van, Huu-Tap; and Nguyen, Thi-Minh-Thu
(2026)
"Ammonium Adsorption from Aqueous Solutions Using MnFe2O4-Functionalized Coffee Husk Biochar Nanocomposites : An Evaluation of HNO3 and NaOH Activation,"
Applied Environmental Research: Vol. 48:
No.
3, Article 6.
DOI: 10.35762/AER.2026021
Available at:
https://digital.car.chula.ac.th/aer/vol48/iss3/6
Included in
Civil and Environmental Engineering Commons, Environmental Sciences Commons, Environmental Studies Commons